Holiday Border Tea Towel: A Handmade Hostess Gift to Sew and Share

A plain tea towel becomes a holiday gift with a hemmed fabric band near one end. The band is made first, with its raw edges folded in, then topstitched flat onto the towel. There is no lining or batting, and you measure your own towel instead of trusting a fixed size.

What You'll Make

One plain cotton tea towel with a single hemmed fabric band across its width, near one short end. The finished towel is the size of the towel you start with. The example uses an 18-inch-wide towel.

Materials

Five of the six supply entries (about 83%, by item count) link to Linda's products.

Buying note: start with 1 yard of your chosen fabric — its 36-inch length covers the 5-inch band height many times over, and more than one band fits across the wideback width.

Tools also needed: sewing machine, cutting mat and ruler, measuring tape, pins, iron, and a fabric scrap for stitch testing.

Steps

  1. Wash and press first. If you plan to wash the finished towels, wash the towel and band fabric separately before cutting, following any care labels, and press flat with a suitable heat setting. Prewashing can reduce, not eliminate, later shrinkage risk.
  2. Measure and cut the band. Measure the towel width across the end you will decorate and write it down as W. Cut one rectangle 5 inches tall by W minus 2 inches long — 5 by 16 inches for an 18-inch towel. Check corners are square against the quilting ruler. With the rotary cutter, keep your free hand behind the ruler's edge and fingers clear of the blade, cut away from your body, and close the blade when set down.
  3. Fold and press the band hems. Wrong side up, fold each edge 1/4 inch to the wrong side and press, then fold another 1/4 inch to enclose the raw edge and press again — opposite edges first, then the other pair. The finished band is 4 inches tall by W minus 3 inches: 4 by 15 inches in the example.
  4. Stitch the band hems. Pin the hems, then test stitch and length on the folded scrap and adjust until the stitching sits smoothly. Stitch close to the inner folded edge on all four sides, backstitching at start and end. At each corner, stop with the needle down, lift the presser foot, turn the work, lower the foot, and continue. Remove each pin before it reaches the needle — never sew over pins.
  5. Place the band. Lay the towel flat, right side up. Set the band on the front, its bottom edge about 2 inches above the towel's bottom edge, centered so the side margins are equal. Check both sides with the tape, then pin through band and towel only.
  6. Topstitch the band down. Stitch around the band close to its folded edges, through band and towel, backstitching at start and end. Turn at corners with the needle down as in Step 4, stitch slowly through thicker corners, and remove each pin before it reaches the needle.
  7. Press and check. Press the towel flat with a suitable heat setting. Check no pins remain before you fold, use, or gift it.

Tips

Sizing rule: the cut band is 1 inch taller and longer than the finished band, because the two 1/4-inch folds use up 1/2 inch per side. For a different towel width, keep the 5-inch cut height and change only the length: cut length is W minus 2 inches, finished length is W minus 3 inches. Fit check: before stitching, confirm the side margins match, the band sits straight, and it is about 2 inches above the bottom edge. If it sits crooked, lift and reposition it — do not pull it straight while stitching. For a set, measure each towel separately, because bought towels can vary slightly.

Where to Get Everything

The fabrics, thread, needles, and cutter come from Linda's Electric Quilters. For the plain tea towel, or a missing tool, try a craft or kitchen store, or your local quilt shop.

Enjoying our quilting guides? Add Linda's as a preferred source on Google to see more of them in your search results: