Quilted Christmas Tree Napkins: A Festive Touch for Every Place Setting

A little quilted tree at every place setting turns a plain holiday table into a celebration. The napkins are reversible — green on one side, red on the other.

What You'll Make

Four quilted Christmas tree napkins, each finished about 12 and 1/2 inches tall by 10 and 1/2 inches wide, green on one side and red on the other, with stitched lines across the branches. Use one at each setting, or as a festive mat under a plate or mug.

Materials

Eight of nine entries link to Linda's — about 89% by entry count.

Buying note: allow 1 yard each of green and red. After preparation, each piece must still measure at least 30 by 43 inches usable — the four tree shapes need a 26 by 22 inch area, laid two across and two down, and the rest covers test scraps. Prewash both cottons if you plan to wash the napkins; batting may shrink on washing, so finished size may change slightly — wash finished napkins gently and press flat.

Tools also needed: sewing machine, cutting mat, pins, removable marker, iron, and test scraps.

Steps

  1. Make the template and test. On the paper, draw one tree outline 13 inches tall by 11 inches wide at the widest tier, with three branch tiers and a trunk section 2 inches wide by 1 and 1/2 inches tall centered at the bottom. Cut out the template; it should extend beyond a dinner plate on both sides. Press both cottons. Switch the machine off before changing the needle. Fit a needle compatible with your machine, fabric, and thread; test stitch and marker on layered scraps.
  2. Cut the layers. Trace the template onto each fabric and the batting; cut four trees from each on the drawn line. Use the rotary cutter and ruler for straight trunk edges, the scissors for tier points, or scissors throughout. Hold the ruler with your non-cutting hand, fingers inside its edge, away from the blade path. Close the blade after every cut.
  3. Layer and sew one napkin. Stack one batting tree, one green tree right side up, and one red tree right side down, edges even. Pin around the tree, then stitch with a 1/4-inch seam, pivoting at each tier point with the needle down, backstitching at start and end, and leaving a 3-inch gap in one straight bottom edge of the lowest tier, beside the trunk. Remove each pin before it reaches the needle — never sew over pins.
  4. Trim and turn. Trim the batting close to the stitching, and clip straight cuts into the inner corners of the tiers, stopping short of the stitches. Turn the napkin right side out through the gap; ease the points out with a blunt turner or your fingers, not a sharp point. Fold the gap edges in 1/4 inch. Press flat, fingers clear of the soleplate and steam. Expect about 12 and 1/2 by 10 and 1/2 inches at the tallest and widest points; hand-drawn tiers vary, so measure the first napkin and match the rest to it.
  5. Topstitch and quilt. Topstitch all around, 1/8 inch from the edge, closing the gap as you sew and pivoting at the tier points with the needle down. Mark three gentle lines across the tiers, spaced so no two neighboring stitched lines are more than 4 inches apart, counting the edge topstitching as the outer lines, and stitch along them through all layers to suggest branches, backstitching at each end.
  6. Repeat and check. Repeat Steps 3 to 5 for the other three napkins. Account for the needle and every pin; inspect seams, trim threads, and press each napkin before setting the table.

Tips

Cutting all four napkins before you sew keeps the set consistent, and point-to-point template nesting leaves larger scraps. For a larger mat, enlarge the template evenly and check it against your plate before cutting fabric.

Where to Get Everything

Find the linked fabrics, batting, thread, needles, cutter, ruler, and scissors on Linda's Electric Quilters website. For template paper or a missing tool, check supplies first, or ask a craft store or local quilt shop whether it carries one.

Enjoying our quilting guides? Add Linda's as a preferred source on Google to see more of them in your search results: