Same backing, two different orders

A wideback cut has two dimensions that matter: the width across the fabric, and the length cut from the roll. When you plan a backing, you choose which side of your quilt runs across the width. Rotating that layout by 90 degrees swaps the two numbers, and the yardage you need to order can change. Comparing both orientations on paper takes a few minutes and can save fabric, or reveal that only one orientation works.

The three inputs you need first

Start with your finished quilt top width and length, measured carefully. Next, confirm the backing allowance with your quilter. Allowance is the extra backing needed beyond the top on each side for loading and quilting. There is no universal allowance, so use the per-side figure your own quilter gives you as an input. Finally, use the usable width you measured on your own fabric, not just the nominal width in a product title. For the worked example below, suppose your quilter has confirmed 4 inches per side, and the usable width you measured is 106 inches. Those are example inputs, not rules for every quilt or quilter.

Worked example: an 80 by 96 inch top

Add twice the per-side allowance to each top dimension. The required backing is 80 plus 8, which is 88 inches, by 96 plus 8, which is 104 inches. Now test both orientations against your measured usable width of 106 inches.

Orientation A, as first drawn. Place the 88-inch side across the fabric width. It fits inside 106 inches. The cut length is then the other dimension, 104 inches. Divide 104 by 36 to get about 2.89 yards, so a 3-yard cut, which is 108 inches long, covers the required length.

Orientation B, rotated. Turn the layout so the 104-inch side runs across the fabric width. It still fits inside 106 inches, with 2 inches to spare. The cut length is now 88 inches. Divide 88 by 36 to get about 2.44 yards, so a 2.5-yard cut, which is 90 inches long, covers the required length.

The rotated layout orders half a yard less fabric for exactly the same quilt, the same allowance, and the same backing piece. Nothing about the quilt changed. Only which dimension you paid for as cut length changed.

When rotation does not work

Rotation is only an option when the longer required side also fits across your measured usable width. Suppose a larger top required a backing of 98 by 110 inches. Placing the 98-inch side across a 106-inch usable width fits, but rotating would put 110 inches across that same width, and 110 is more than 106. That orientation fails, however attractive its shorter cut length looks. In that case, keep the working orientation, or plan a pieced backing instead.

Also check the print before you decide. A directional print will run a different way when you rotate the layout, and that may matter more to you than a half-yard saving. Rotation is a planning choice, not an instruction to turn a design sideways.

A quick comparison to run every time

Write down the required backing width and length. Test the shorter side across your usable width and note the cut length. Then test the longer side across, and note that cut length only if it fits. Convert each cut length to yards by dividing by 36, and round each result up to an amount you can actually order. Compare the two order amounts, check the print direction, and order for the orientation you will really use.

For the underlying backing math, see Quilt Backing Math: How Much Wideback Fabric Do You Really Need? Run both layouts on paper first, and the cheaper, workable option will usually be obvious before you buy.

Enjoying our quilting guides? Add Linda's as a preferred source on Google to see more of them in your search results: