Hey everyone, this is the 3 Yard 110in Cuddle Cut Teal, our classic Solid Cuddle 3 minky plush fabric. Today you'll learn to make a lap quilt, 50 by 60 inches, with a one-piece Teal top.
Meet the Fabric First
It comes as a wide back pre-cut, 3 yards (108 inches long), at 108 to 110 inches wide. It is 100% polyester.
Teal is this cut's color name. Its surface is smooth and ultra-soft, beautiful and durable, with a versatile 3mm pile.
Why It Suits a Lap Quilt
One Teal panel covers this quilt's 50 by 60 inch top in one piece. The quilting lines hold the layers together.
What You Will Need
- 3 Yard 110in Cuddle Cut Teal fabric, for one top panel cut 52 by 62 inches
- Backing fabric, one panel cut 56 by 66 inches
- Batting, one piece cut 56 by 66 inches
- Binding fabric, cut into 2 1/2-inch strips, joined into one strip at least 240 inches long
- Small scraps, about 6 inches square, of your Teal, backing, and batting, for the test seam
- All-purpose thread
- Sewing machine with a walking foot
- Size 90/14 stretch or ballpoint needle
- Rotary cutter, cutting mat, and a long ruler
- Long pins or quilting clips
- Fabric scissors, measuring tape, and fabric marker or chalk
- Hand-sewing needle
- Seam ripper
Brief Steps to Make It
Step one, lay the Teal flat. Smooth it by hand.
Step two, mark the top panel at 52 by 62 inches, check square, then cut.
Step three, cut backing and batting at 56 by 66 inches each.
Step four, test first. Layer the listed scraps: backing right side down, batting, Teal pile side up. Sew with the walking foot, stitch length 3.0 to 3.5. Backstitch three stitches at the start and at the end. Check both sides: even stitches, flat layers.
Step five, layer the sandwich. Backing right side down, batting in the middle, Teal on top, pile side up, centered so batting and backing extend 2 inches per side.
Step six, pin baste, every 4 to 6 inches. Mark the 50 by 60 inch rectangle, centered, on top.
Step seven, quilt with the walking foot. Sew parallel lines lengthwise, along the 62-inch direction, 4 inches apart across the 52-inch width. Start with one center line, then work outward to each side. Run every line from one raw short edge to the other. Do not stop inside the quilt and do not backstitch. Those ends sit in the extra area. Step eight trims that area away, and the binding covers the remaining ends.
I rushed a line once and it wandered. I took it out with the seam ripper and sewed slower.
Step eight, trim all three layers on the marked lines, to 50 by 60 inches.
Step nine, bind it. Join your strips: lay two strips right sides together at a right angle. Sew diagonally corner to corner across that square. Trim to 1/4 inch past that seam, finger-press it open. Repeat until the strip reaches at least 240 inches: the 220-inch edge, plus 20 for corners, joins, and tails. Fold it in half lengthwise, wrong sides together. Start halfway along one long edge, leaving a 12-inch loose tail, raw edges aligned with the front edge. Sew at a 1/4-inch seam allowance. That seam crosses every quilting line end, securing each one before the binding folds over it. Stop 12 inches before the point where your stitching began, leaving a gap and a second tail.
At each corner, stop 1/4 inch short and backstitch. Fold the strip up at a 45-degree angle, then straight down along the next edge, fold flush with the sewn edge. Sew from the outer edge, same allowance.
Join the tails: lay the ending tail over the starting tail. Trim it where they overlap by 2 1/2 inches, the strip width. Open both tails flat, right sides together at a right angle. Sew diagonally corner to corner. Trim to 1/4 inch, finger-press open, refold. Sew the gap closed, same allowance. Fold the binding to the back, its folded edge covering the front stitching line by 1/8 inch. At each corner, fold one side down, then the other, for a diagonal fold. By machine, stitch in the ditch on the front, catching that edge on the back. Backstitch three stitches at the start and at the end to secure it. By hand, slipstitch that edge down with the hand-sewing needle. Start with a knotted thread. At the end, take one backstitch, knot it, and bury the tail.
Practical Tips From My Table
Keep your leftover Teal for test seams.
It does not have to be perfect.
Thanks for sewing along with me. We'll see you next time. Bye.
Shop the 3 Yard 110in Cuddle Cut Teal at Linda's Electric Quilters.




